/*!
    \file    readme.txt
    \brief   description of the TIMER0 output composite PWM and output match pulse demo for GD32F50x

    \version 2026-02-25, V1.0.4, firmware for GD32F50x
*/

/*
    Copyright (c) 2026, GigaDevice Semiconductor Inc.

    Redistribution and use in source and binary forms, with or without modification, 
are permitted provided that the following conditions are met:

    1. Redistributions of source code must retain the above copyright notice, this 
       list of conditions and the following disclaimer.
    2. Redistributions in binary form must reproduce the above copyright notice, 
       this list of conditions and the following disclaimer in the documentation 
       and/or other materials provided with the distribution.
    3. Neither the name of the copyright holder nor the names of its contributors 
       may be used to endorse or promote products derived from this software without 
       specific prior written permission.

    THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" 
AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED 
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. 
IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, 
INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT 
NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR 
PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, 
WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 
ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY 
OF SUCH DAMAGE.
*/
 
    This demo is based on the GD32F503V-EVAL-V1.1 board, it shows how to configure TIMER0_CH0
 / CH1 in composite PWM mode and TIMER0_CH2 output match pulse.

  TIMER0 configuration:
  - CH0, CH1 and CH2 output composite PWM waveform.
  - CH2 enable the output match pulse function.

  TIMER0 frequency = CK_TIMER/252 = 1MHz. The PWM frequency is 1MHz / (99 + 1) = 10KHz.
  - CH0 configuration in composite PWM mode, the high level duty cycle 80% (100 % - (60 - 40) / 100 * 100%).
  - CH1 configuration in composite PWM mode, the high level duty cycle 20% ((60 - 40) / 100 * 100%).
  - CH2 will output 2 pulses when the matching event occurs.

 