/*!
    \file    readme.txt
    \brief   description of the CAN Pretended Networking mode demo

    \version 2026-02-04, V1.3.0, firmware for GD32H75E
*/

/*
    Copyright (c) 2026, GigaDevice Semiconductor Inc.

    Redistribution and use in source and binary forms, with or without modification, 
are permitted provided that the following conditions are met:

    1. Redistributions of source code must retain the above copyright notice, this 
       list of conditions and the following disclaimer.
    2. Redistributions in binary form must reproduce the above copyright notice, 
       this list of conditions and the following disclaimer in the documentation 
       and/or other materials provided with the distribution.
    3. Neither the name of the copyright holder nor the names of its contributors 
       may be used to endorse or promote products derived from this software without 
       specific prior written permission.

    THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" 
AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED 
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. 
IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, 
INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT 
NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR 
PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, 
WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 
ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY 
OF SUCH DAMAGE.
*/

  This demo is based on the GD32H75EY-EVAL-V1.0 board, it shows how to configure the 
CAN0 peripheral to Pretended Networking mode, and CAN2 peripheral to transmit wakeup frame.

  When TAMPER button is pressed, CAN1 enters Pretended Networking mode. If WAKEUP button is
not pressed within (0xFFFF * 64 / 500K = 8.38) seconds, a wakeup timeout event is occurred,
and LED2 will be toggled, otherwise CAN2 will send a wakeup frame, and a match event will
occur, LED1 is toggled, the received data will be printed inthe hyperterminal.

  User must connect L pin to L pin, and H pin to H pin of JP14 and JP16 on the board for sending and 
receiving frames.

  GD32H75EY-EVAL-V1.0 board CAN transceiver needs 5V power supply.
