/*!
    \file    readme.txt
    \brief   description of EXMC SDRAM DeepSleep demo

    \version 2026-02-06, V1.4.0, demo for GD32F527
*/

/*
    Copyright (c) 2026, GigaDevice Semiconductor Inc.

    Redistribution and use in source and binary forms, with or without modification,
are permitted provided that the following conditions are met:

    1. Redistributions of source code must retain the above copyright notice, this
       list of conditions and the following disclaimer.
    2. Redistributions in binary form must reproduce the above copyright notice,
       this list of conditions and the following disclaimer in the documentation
       and/or other materials provided with the distribution.
    3. Neither the name of the copyright holder nor the names of its contributors
       may be used to endorse or promote products derived from this software without
       specific prior written permission.

    THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT,
INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR
PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY
OF SUCH DAMAGE.
*/

  This example is based on the GD32F527I-EVAL-V1.0 board, it shows how to use EXMC peripheral
to control SDRAM memory work with PMU(deepsleep mode).
  Firstly, write data to SDRAM, then make MCU into deepsleep mode and light on LED2.
Secondly, press the USER key to wakeup the MCU. After wakeup, MCU read data from SDRAM
and compare with the data we written just now. If the test correct, LED1 will be 
turned on. Otherwise,turn on the LED3.
  The timing parameters are calculated according to the 200MHz system clock.
  
  JP10 must be fitted to the SDRAM port, JP21 must be fitted to the USART port.
