/*!
    \file    readme.txt
    \brief   description of the TIMER1 single pulse demo

    \version 2023-08-01, V1.0.0, HAL firmware for GD32F3x0
*/

/*
    Copyright (c) 2023, GigaDevice Semiconductor Inc.

    Redistribution and use in source and binary forms, with or without modification, 
are permitted provided that the following conditions are met:

    1. Redistributions of source code must retain the above copyright notice, this 
       list of conditions and the following disclaimer.
    2. Redistributions in binary form must reproduce the above copyright notice, 
       this list of conditions and the following disclaimer in the documentation 
       and/or other materials provided with the distribution.
    3. Neither the name of the copyright holder nor the names of its contributors 
       may be used to endorse or promote products derived from this software without 
       specific prior written permission.

    THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" 
AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED 
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. 
IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, 
INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT 
NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR 
PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, 
WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 
ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY 
OF SUCH DAMAGE.
*/

  This demo is based on the GD32350R-EVAL board, it shows how to configure the TIMER1 
peripheral in single pulse mode.

  The external signal is connected to TIMER1 CH0 pin (PA0) and the falling 
edge is used as active edge.

  The single pulse signal is output on TIMER1 CH1 pin (PA1).

  The TIMER1 clock frequency is set to systemcoreclock 108MHz for GD32F350,
the prescaler is 9(GD32F350),so the TIMER1 counter clock is 12MHz.

  single pulse value = (TIMER1_Period - TIMER1_Pulse) / TIMER1 counter clock
                     = (41999 - 20999) / 12MHz = 1.75 ms.

  Connect the TIMER1 CH0 pin (PA0)to KEY , When KEY is pressed,a single pulse is generated.
